Details
Suppressor Ready Evermore 16-inch 8.6 Blackout AR-10 Complete Upper
The Evermore is built around a BC-10 16-inch SOCOM barrel chambered in 8.6 Blackout, finished in Parkerized. It's paired with an AR-10 high-profile upper receiver finished in black anodizing. It pairs an Omega Mfg SCRAAM-48 12-inch super slim high-profile KeyMod handguard with a threaded M18x1.5 muzzle left bare, giving this build a Suppressor Ready configuration since no muzzle device is installed on that threading. It runs on a carbine-length gas system. A Recoil Technologies LR-308 bolt carrier group, rated for 8.6 Blackout, and an LR-308 aluminum charging handle round out the upper, giving the buyer everything needed on the upper side.
Key Features
- BC-10 16-inch SOCOM 8.6 Blackout barrel, 1:3 twist, Parkerized finish
- Carbine-length gas system with adjustable low-profile gas block
- AR-10 high-profile upper receiver, black anodized finish
- Omega Mfg SCRAAM-48 12-inch super slim high-profile KeyMod handguard
- M18x1.5 threaded muzzle, Suppressor Ready; no muzzle device included
- Recoil Technologies LR-308 bolt carrier group, nitride finish, 8.6 Blackout rated
- LR-308 aluminum charging handle included
Barrel and Gas System
The BC-10 barrel runs 16 inches long, chambered in 8.6 Blackout and finished in Parkerized with a SOCOM profile. It carries a 1:3 twist rate, suited to stabilizing the heavy-for-caliber projectiles this chambering runs, along with an M18x1.5 muzzle thread. Gas cycles back to the action through a carbine-length system, running a stainless steel carbine-length gas tube and a standard low-profile adjustable gas block machined from Melonite steel, sized to an .875-inch journal.
Upper Receiver and Handguard
The upper receiver is an AR-10 high-profile unit finished in black anodizing, fitted with an AR-15 forward assist assembly and an LR-308 ejection port door assembly. Over the barrel sits an Omega Mfg SCRAAM-48 handguard, 12 inches long in a super slim, high-profile design, using a KeyMod attachment system along its length.
Suppressor Ready
The barrel is threaded M18x1.5 at the muzzle, but no muzzle device is installed on that threading, which is what makes this build Suppressor Ready. The bare threaded muzzle leaves that end open for the buyer's own suppressor mounting solution.
Bolt Carrier Group and Charging Handle
A Recoil Technologies LR-308 bolt carrier group is included, finished in nitride and rated for 8.6 Blackout to match the chambering of this build. An LR-308 aluminum charging handle rounds out the upper's operating components.
Follow all manufacturer instructions and safe handling practices.
Ensure compliance with all applicable federal, state, and local laws.
Verify suppressor and mounting-system compatibility before use.
