Davidson Defense Suppressor Ready Phasebreak 16-inch Carbine-Gas 1:3 8.6 BLK AR-10 M-Lok Rifle Complete Upper Build

Suppressor Ready Phasebreak 16-inch 8.6 Blackout AR-10 Complete Upper

The Phasebreak is built around a 16-inch BC-10 barrel chambered in 8.6 Blackout, with a SOCOM profile finished in Parkerized. It's paired with an LR-308 billet upper receiver machined to the DPMS low-profile pattern. It pairs a 15-inch "Friz" low-profile LR-308 M-LOK handguard with a threaded M18x1.5 muzzle left bare, giving this build a Suppressor Ready configuration since no muzzle device is installed on that threading. A Recoil Technologies nitride LR-308 bolt carrier group and aluminum LR-308 charging handle round out the upper, giving the buyer everything needed on the upper side.

Key Features

• BC-10 16-inch 8.6 Blackout barrel, 1:3 twist, SOCOM profile
• Carbine-length gas system with adjustable low-profile gas block
• LR-308 billet upper receiver, DPMS low-profile pattern, no forward assist
• "Friz" 15-inch low-profile LR-308 M-LOK handguard
• M18x1.5 threaded muzzle, Suppressor Ready; no muzzle device included
• Recoil Technologies nitride LR-308 bolt carrier group, 8.6 Blackout rated
• Aluminum LR-308 charging handle included

Barrel and Gas System

The BC-10 barrel runs 16 inches long, chambered in 8.6 Blackout and finished in Parkerized with a SOCOM profile. It carries a 1:3 twist rate, suited to stabilizing the heavy-for-caliber projectiles this chambering runs, along with an M18x1.5 muzzle thread. Gas cycles back to the action through a carbine-length system, running a stainless steel carbine-length gas tube and a standard low-profile adjustable gas block machined from steel with a Melonite finish, sized to a .875-inch journal.

Upper Receiver and Handguard

The upper receiver is a billet unit built to the DPMS low-profile pattern, finished in Type III hardcoat black anodizing and machined without a forward assist. The ejection port door ships assembled. Over the barrel sits a 15-inch "Friz" low-profile LR-308 handguard, using an M-LOK attachment system along its length.

Suppressor Ready

The barrel is threaded M18x1.5 at the muzzle, but no muzzle device is installed on that threading, which is what makes this build Suppressor Ready. The bare threaded muzzle leaves that end open for the buyer's own suppressor mounting solution.

Bolt Carrier Group and Charging Handle

A Recoil Technologies nitride LR-308 bolt carrier group is included, rated for 8.6 Blackout to match the chambering of this build. An aluminum LR-308 charging handle rounds out the upper's operating components.

Follow all manufacturer instructions and safe handling practices.

Ensure compliance with all applicable federal, state, and local laws.

Verify suppressor and mounting-system compatibility before use.